There are more and more types of labeling machines, one of which is the automatic labeling machine, which is a kind of equipment commonly used in factories. It adopts the improvement of automation technology.
It brings great convenience to the factory, and in order to effectively improve the labeling effect of the automatic labeling machine, and to improve some bad factors to a large extent, it needs timely
Improve the automatic labeling machine system, and turn the stainless steel strip on the drum to the beef tendon. Let's take a look at the following:
At this stage, the tendon pads have been widely used in the automatic labeling machine, which has the following advantages: First, according to the tendon label, it can have good resilience。
Greatly reduce the pinching phenomenon when removing the drum mark。 Second, the tendon pads have a good coefficient of friction, and the appearance is relatively lubricated, which can smoothly take the mark。 third,
The equipment wears slowly and can be used stably for a long time. Under the premise of the original three-row trademark machine brush, add two more rows of brushes so that the brush can be fully improved.
Tightening force ensures that the labeling can be stopped more smoothly. Before the labeling of the back label, it is necessary to properly install the oblique brush, which has an angle of about 70°. One is automatic labeling
Properly participate in the sponge roller in the machine to reach the phenomenon of bubbling, curling, and wrinkling in the middle of the labeling machine in time. Second, the sponge roller is softer than the one.Not
only will it not harm the bottle, nor will it wear the mark. Third, the brush is properly erected in front of the sponge roller, the backing is stopped, and the sponge roller is pressed again.The
protection has become more even. After improving the automatic labeling machine, the performance has improved a lot, so that it can effectively deal with wrinkles, bubbling, and printing.
,Ensure that the labeling machine has a better application effect. If you want to handle the automatic labeling machine, you need to change the shape of the label and make the bottom of the label curved.
,Try to avoid the deformation zone of the seal。 Of course, the arc can't be opened too deeply, otherwise it will easily cause wrinkles due to the label's own problems, adding unnecessary troubles。For
the profiled seal, the shape of the requested label should be changed accordingly, which not only prevents the tilting of the label but also increases the aesthetics.